Dali IKON 1 Operations Instructions download pdf (Page 14)

14

PRE-AMPLIFIER

LINE OUTPUT

POWER AMPLIFIER

LINE IN

If you want to use IKON SUB to supplement the

bass reproduction of a stereo system, connect

the subwoofer "Line in, Left/Right" to a stereo

signal on the pre-ampliﬁ er with full frequency

content. The built-in crossover network in IKON

S

UB then ensures that the subwoofer only repro-

duces the lowest frequencies (see section on

level adjustment and adjusting the crossover on

page 15 and 16).

In most cases you will achieve excellent results

with one IKON S

UB. It is possible as a no-compro-

mise stereo solution, or for reproduction of very

powerful sound pressure in a surround setup in

large rooms, to use two IKON S

UBs. This solution

is connected in the same way, but for stereo you

should only connect the left-hand channel to one

input terminal on the left-hand IKON S

UB and

the right-hand channel to one input terminal on

the right-hand IKON S

UB. For a surround setup,

parallel the LFE inputs of the two IKON S

UB. In

all other respects, follow the instructions above

- but use separate channels. You may wish to

consult your dealer.

Note: When using two IKON S

UB, the best results

are normally achieved by positioning the two

subwoofers relatively close to each other (1 - 2

metres).

Connection to a stereo pre-ampliﬁ er

Figure 18.

Connection to stereo preampliﬁ er

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Comments to this Manuals

No comments